Electrolux Washer No Water Error Message

If they are clogged flush them out.

Electrolux washer no water error message.

Tap closed or water pressure too low. The error is caused by water at the bottom or inside the machine. Leaks from water circuit on pressure switch. Water fill solenoid valve is faulty.

Water fill solenoid valve is faulty. Disconnect the fill hoses from the back of the washer and put them in a 5 gallon bucket. Check the little filter screens where the fill hoses connect to the back of the washer. Drain tube improperly dositioned.

Leaks from water circuit on pressure switch. If the hoses are good and you haven t found anything slowing down the flow of the water your electronic inlet water valve is just faulty on the back of your washer and will need to be replaced because it s just not allowing water flow into the washer correctly. Turn the water off and remove the hoses from the back of the washer. Turn the water on to make sure you have good water pressure from both hot and cold water lines.

Washer dryer displays error message e30 c3 or emits 3 beeps. You ll need to pull the washer forward and turn the water off to the washer.