Easiest Way To Pull Up Laminate Flooring

Remove the rest of the flooring boards in the same way disengaging the ends and then pushing the boards toward the wall.

Easiest way to pull up laminate flooring.

For proper installation the subfloor or old flooring surface must be flat smooth and clean. Reach under the edge of a laminate strip and pull it back towards you. Remove the top layer of flooring material with a scraper or oscillating tool. Working in sections apply heat to soften the bottom.

Pull it up and back towards you at about a 45 degree angle. Start at one edge of the flooring and slide your fingertips under the edge of the outermost strip of laminate. Laminate flooring can usually be installed successfully right over old floor coverings such as sheet vinyl provided the surface is flat and smooth and not soft or cushiony. A simple underlayment of foam sheeting is usually sufficient as a base for laminate planks.

Prepare the subfloor. Place the tip of the curved end of the pry bar in the space between the first row of planks and the wall. Start the disassembly in one of the corners on the groove side. Using a utility knife score the flooring into 6 12 strips.

From the second course onward you should be able to separate boards by. Floating laminate floors are the easiest to remove because they are not glued down to the concrete and are merely snapped together. In order to separate the boards easily it s important to pull them toward that side. The planks are easier to remove if you begin from the tongue side rather than the side with the groove.

Using a hammer drive the tip of a wood chisel between the flooring and subfloor to loosen the edge of the flooring. Place a clean rubber faced grouting float on. In this video i am showing how to install laminate flooring for the first time.